DYNAVIS® INJECTION MOLDING CALCULATOR
How to use the calculator properly
Reduction of energy consumption is a just click away!
- Open the calculator
- Select the desired calculation section
- Position the sliders located in the right box to reflect your situation
- Adjust further parameters in settings
- Visualize the potential energy consumption savings
The calculator is based on a hydraulic energy efficiency improvement of 5% versus operation with a conventional monograde ISO VG 46 fluid. The absolute energy consumption depends on the operating parameters of the equipment, such as operation time, operating temperature, hot or cold climates, equipment type etc. The absolute values as shown by the calculator are not a guarantee that you will obtain the same results as calculated.
This information and any technical advice provided is based on our present knowledge and experience. There is no liability or other legal responsibility on our part, such as, but not limited to, stated or implied, and including that with regard to existing third party intellectual property rights, especially patent rights. No warranty and no guarantee of additive or formulated fluid properties in the legal sense is stated or implied. We reserve the right to make any changes to accommodate technological progress and/or further development.